Start by connecting an ECM8000 mic (or equivalent) to the RTA/MIC input on the DEQ2496, then turn on power to the unit.
Press the I/O button, and go to page 3 in the menu. Use the large DATA WHEEL to select RTA/MIC as the input.
Use softkey A to select 'MIC'.
Use softkey B to highlight mic +15 V? (to apply phantom power to the mic).
Press the RTA button.
Use the top small DATA WHEEL to adjust the MAX parameter (to set the 'top' range of signal that can be viewed in the display. A suggested starting setting is '-60 dB'.
At this point, you can use the large DATA WHEEL to select a frequency at which you wish to view the dB level in the display. A suggested starter setting is '90 dB?'.
Use the bottom small DATA WHEEL to determine how much dynamic range in dB is visible in the display.
Press the RTA button to go to page 2 in the menu, and use soft key A to determine the 'refresh' speed (FAST, MID, SLOW, or AVRG) for the dB level readings in the display. We recommend starting with 'MID' or 'SLOW'.
Use soft key B to determine how signal peaks are shown in the display. You can choose between FAST, MID, SLOW, HOLD, or OFF.
|Product Category||Signal Processors|
|Product||ULTRACURVE PRO DEQ2496|