Home > BEHRINGER > FCA- How Do I Connect My FCA1616 To My ADAT Compatible Device?

FCA- How Do I Connect My FCA1616 To My ADAT Compatible Device?

Table of contents
 

 

 

 

 

 

 

 

 

On the FCA1616, to get ADAT signal from an external ADAT compatible device into the FCA1616 will require the use of two optical cables. This is due to the fact that the FCA1616 will need to be the master device in this particular configuration.

1. Connect the ADAT OUTPUT of the FCA1616 to the ADAT INPUT of the external ADAT compatible device. Have this device set to SLAVE.


2. Now, connect the ADAT OUTPUT of the external ADAT compatible device to the ADAT INPUT of the FCA1616.


3. You will then select ADAT using the DIGITAL SELECT BUTTON on the front of the FCA1616. Give the unit just a few seconds to sync up properly.

You should now be able to use the FCA1616 with your external ADAT compatible device. 

You must to post a comment.
Last modified
21:42, 13 Apr 2016

Tags

Classifications

This page has no classifications.